Settings: Password - STA-RITE IntelliPro Variable Speed Installation And User Manual

12

Settings: Password

When the Password feature is enabled, the pump will enter into password protection mode for a pre
programmed amount of time after the last button is pressed. The entered password is any combination
of four (4) digits.
To access the Password menu:
1. Check that the green power LED is on.
2. Press the Menu button. "Settings" is displayed.
3. Press the Select button. "Pump Address" is displayed.
4. Use the Up or Down arrow button to scroll to "Password".
5. Press the Select button. The default setting is "Disabled".
6. Press the Select button to change the setting.
7. Press Up or Down arrow button to change the setting to Enabled".
8. Press the Enter button to save the setting.
9. Press Down arrow button. "Password Timeout" is displayed.
Factory default time is 10 minutes; this means the pump will go into Password Protection
mode 10 minutes after the last control panel key press.
10. Press Select to change time setting from 1 minute to 6 hours.
11. Press the Enter button to save the setting.
12. Press Down arrow button. "Enter Password" is displayed.
13. Press Select to change the setting.
14. Press Left or Right arrow button to move cursor and press up and down arrow to change
password number to desired setting.
15. Press the Enter button to save the setting. To cancel any changes, press the Escape button to
exit edit mode without saving.
16. Press the Escape button to exit.
®
IntelliPro Variable Speed Pump Installation and User's Guide