Memory Configuration - DTK PAM-0052V User Manual

2.10 MEMORY CONFIGURATION

The mainboard lets user upgrade system memory via SIMM or DIMM sockets on the
mainboard. On board memory is located in three banks: Bank 0 – Bank 2. Two
SIMM sockets (SIMM1, SIMM2) are provided for SPM, FPM and EDO RAM
SIMM and two DIMM sockets (DIMM1, DIMM2) are available for the 3.3V
unbuffered SDRAM and EDO DIMM.
Note: The type of SIMM1/SIMM2 must be same.
Only 3.3V unbuffered DIMM can be used.
Both single sided and double sided SIMM or DIMM can be supported.
Table 4 provides the typical memory configurations supported by the mainboard.
Bank 0
(SIMM1/2)
Installed
Installed
None
Installed
None
Installed
None
The memory size of SIMM can be 8MB, 16MB, 32MB or 64MB. The memory of
DIMM can be 8MB, 16MB, 32MB, 64MB or 128MB.
Important: When 100MHz DRAM speed is selected. SDRAM DIMMs with
PC100 specification and Serial Presence Defect (SPD) data structure
are required.
We highly don't recommend the mix combination of SIMMs and
DIMMs, especially when 100MHz DRAM speed is selected.
Bank 1
(DIMM1) (DIMM2)
None
Installed
Installed
None Installed
None Installed
Installed Installed
Installed Installed
Table 3
Jumper Settings
Bank 2
None
None
None
13