Comtech EF Data XTRT-400C Operation And Installation Manual page 107

Initial Setup and Operation
General
The amplifier can be operated from the Front Panel (LOCAL configuration) or from a
remote controller (REMOTE configuration). The amplifier is configured at the factory
with the default values shown in table 1. These values allow immediate operation of the
amplifier when the amplifier is connected to an operational load or a dummy load
capable of dissipating rated RF output power.
Parameter
Gain
Local/Remote
RF Inhibit
System Offset
Max Power Trip
Min Power Trip
Max Reflected
Power
Audio Alarm
COM 1
COM 2
Ethernet
Constant Power
Heater Standby
HV state @startup
Power Units
Temperature Units
Table 2. Default Values
Note: Refer to the chapter titled Overview for general amplifier specifications and chapter 8, System
operation XTRT series amplifiers for specifications that are specific to your particular amplifier.
MNC-0400-071
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
Default Value
Minimum Gain
LOCAL
OFF
0.0 dB
OFF
OFF
OFF
ON
9600 Baud, 8/1, None
Address "A" 9600 Baud,8/1, None
DHCP
OFF
ON
Restore
dBm
Centigrade
Page 47 of 53
Operation
Revision 4