IDTECK Star 505R User Manual page 30

12.1.13 DURESS MODE SETTING
DURESS MODE SET
<ENT>
DURESS MODE SET
NOT USE
DURESS MODE SET
-> USE
DURESS P/W
00
12.1.14 FUNCTION KEY SETTING (SR505 FUNCTION)
FUNCTION KEY
NOT USE
FUNCTION KEY
-> NOT USE
<ENT>
<ENT> NOT USE(default)
key<4> or <6>
DURESS P/W
ENTER NEW P/W
(2digit + <ENT>)
☞. You can select whether the DURESS mode is used for
READER1. Default setting is NOT USE. If you want to
setup Duress mode, press the <ENT> key and select -
>USE by pressing the <4> or <6> key. Press the <ENT>
key. The LCD will display default Duress Password '00'.
Press <ENT> key again to enter a 2 digits Duress
Password. Press <ENT> key to finish the setting.
Note!!
In case of Duress, enter the 2 digits Duress Password
and press <ENT> key. Afterwards present the card. Door
will be opened as normal but the Duress alarm will be
generated and reported to the host PC.
☞. The User can decide what will be shown on display
matched with Function key. Default value for FUNCTION
KEY is "NOT USE" and set "USE" in order to apply
FUNCTION KEY F1, F2, F3, F4 for Time & Attendance. If
WAIT TIME is set, system will be back to default status
(display [OK]). Press "ENT" key to change the value from
left figures.
30
USE
<ENT>
<ENT>