IDTECK Star 505R User Manual page 26

12.1.1 READER 1 MODE SETTING
READER 1 MODE
READER 1 MODE
RF ONLY
READER 1 MODE
-> RF ONLY
READER 1 MODE
-> RF+PW
READER 1 MODE
-> PIN ONLY
* READER 2 MODE setup is the same as above.
* The SR505 doesn't have READER 2 MODE. It is used RF + PASSWORD mode only Reader #1.
12.1.2 TIME SETTING
TIME SETTING
YYYYMMDDhhmmssW
_ _ _ _ _ _ _ _ _ _
12.1.3 ANTI-PASS-BACK MODE SETTING
APB SETUP
NOT USE
<ENT>
☞. READER 1 MODE is set to RF ONLY operating mode.
If you want to change the mode to RF+PASSWORD
operating mode, press <ENT> key.
☞. Now you can change the mode by pressing the <4> or
<6> key to toggle the mode. If you want to setup the
mode displayed, press <ENT> key to accept this mode.
Note:
RF ONLY: The door is accessible with the proximity card
alone.
RF+PW: The door is accessible with the proximity card
PIN ONLY: The door is accessible with the PIN number
(4-6 digits).
If you select PIN, it will be affected to Reader 1 and 2.
Press <ENT> key and enter 15 digit Date/Time codes
☞
.
then <ENT> key to finish setting.
YYYY: Year, MM: Month, DD: Date
hh: Hours (24 hours system), mm: Minutes,
ss: Seconds
W: Sun=1, Mon=2, Tue=3, Wed=4, Thu=5, Fri=6, Sat=7
Example: 200302101330152
=> Feb.10, 2003 13:30:15, Mon
☞. It shows anti-pass-back operation is not in use.
Press <ENT> key.
(It only applies when the door has an Exit Reader)
26
RF Only (default)
key<4> or <6>
RF+PASSWORD
key<4> or <6>
PIN (4~6 Digit)
and Password.