IDTECK Star 505R User Manual page 28

EVENT CLEAR
1 - Yes, 0 - No
12.1.7 MASTER ID CHANGE
MASTER ID CHANGE
MASTER ID CHANGE
1:Card 2:Key
Scanning...
MASTER ID CHANGE
[________]
XXXXXXXX
[____]
Registered
Master Card
Registered
The Master ID for 505R is 10 digits number (Default setting "0000000000").
12.1.8 SYSTEM INITIALIZE
SYS INITIALIZE
SYS INITIALIZE
1 – Yes, 0 - No
※ CAUTION: Before you clear the events, make sure
that the stored events is not necessary to upload to
the host PC otherwise you may lose important data.
☞. Press <ENT> key to change the current Master ID.
You should use the new Master ID to access the setup
menu since the change is finished.
☞. Master ID Number is registered in the controller by RF
cards or through the keypad.
For RF cards, Press <1>key, the keypad, <2>key, or you
can quit the registration by pressing <ESC>key.
☞. The reader is waiting for an RF card which is to be
registered. The card number will appear with a beep as
the card is read. After recognition, the next message will
appear.
☞. This figure appears when you press the <2>key for
through-keypad registration, then you are to enter eight-
digit number.
Eight digit ID: 00000000 ~ 99999999
☞. Enter a new Master password (four digits) and finish
changing by pressing the <ENT> key.
☞. The figure indicates that changing of the Master ID has
been finished successfully.
☞. This operation will initialize the 505R. Press <ENT> key, if
an initialization is needed (First time installation or
resetting in the event of a malfunction).
※ CAUTION: Initializing will erase all stored data
in the memory.
☞. Press the <1> key to initialize or <0> key to cancel
the operation.
28