Operations; Setting Changes - IDTECK Star 505R User Manual

11. Operations

11.1 NORMAL OPERATION
Power on
When the power is applied to 505R, the Red LED is turned on.
Registered card reading
When a registered card (or PIN) is read, the Door (Relay #1) will open for 3 seconds (Default)
with the Green LED on.
Exit Button
To request an exit from the inside, an Exit Button (or an Exit Reader) can be used.
The Door (Relay #1) will open for 3 seconds with the Green LED on.
Alarms
When an unregistered card is read, the access is denied and the alarm (Relay #2) will be
activated for 3 seconds with the Yellow LED on.
11.2 DEFAULT SETTING
When you operate the 505R for the first time or want to initialize the 505R, the controller will setup
all value defaults (factory settings). You can change the settings for the desired application.
Please refer to the APPENDIX for the default setting values.

12. Setting Changes

SETUP F1 MODE
1. READER 1 MODE
2. READER 2 MODE
3. TIME SETTTING
4. APB SETUP
5. COMM ADDRESS
6. BAUD RATE
7. EVENT CLEAR
8. MASTER ID CHANGE
9. SYSTEM INITIALIZE
10. CARD ID CLEAR
11. TIME SCHE CLEAR
12. RF_PIN_INPUT
13. EVENT MEMORY
14. DURESS MODE SET
15. FUNCTION KEY
16. DATA BYTE TYPE
INITIAL DISPLAY
(MODEL NAME, CURRENT TIME)
ID INPUT ?
NO
YES
MASTER ID ?
YES
SETUP MODE
SETUP F2 MODE
1. TIME SCHEDULE
2. HOLIDAY SETTING
3. IN/OUT DEFINE
4. HOLIDAY INDEX
5. MODE INDEX
6. LCD DISPLAY
7. OUTPUT TIME SET
23
NO
OPERATE GENERAL
MODE
SETUP F3 MODE
1. ID REGISTRATION
2. ID DELETE
3. ID LIST
4. REG. ID COUNT
5. ID COUNT
SETUP F4 MODE
1. VERSION
2. SRAM TEST
3. OUTPUT TEST
4. LCD TEST
5. KEYPAD TEST
6. READER TEST
7. INPUT TEST
8. COMM TEST