Console (Fig. E-1) - Tunturi FitRun 70i User Manual

GB
⚠ CAUTION
• Before folding the equipment, make sure that the incline is 0%� If
the incline is not 0%, folding will damage the mechanism�

Console (fig. E-1)

⚠ CAUTION
• Keep the console away from direct sunlight�
• Dry the surface of the console when it is covered with drops of
sweat�
• Do not lean on the console�
• Only touch the display with the tip of your finger� Make sure that
your nails or sharp objects do not touch the display�
‼ NOTE
• The console switches to standby Mode when the equipment is
not used for 10 minutes�
Press any key to wake up console again when being in standby
Mode�
Buttons
Start
- Start selected workout
Stop
- Pause the training (in workout Mode)�
- Stop the active training� ( in pause Mode )
- Clear value in programming Mode�
- Reset console when press and hold for 2 seconds in "stop Mode"
Incline up
- Increases the incline (0~15 ±1)�
- Scroll programs and change values in programming Mode�
Incline Down
- Decreases the incline (0~15 ±1)�
- Scroll programs and change values in programming Mode�
Incline hot keys�
Incline Hot Keys are set as: 6, 8 & 10�
For example, the incline level changes from any level
to 8 by pressing the Incline Hot Key 8�
Speed Up
- Increases the speed (0�8~20�0 Km/h ±0,1Km/h)�
- Pressing and holding will increase the speed faster�
- Scroll programs and change values in programming Mode�
Speed Down
- Decreases the speed (0�8~20�0 Km/h ±0,1Km/h)�
- Pressing and holding will decrease the speed faster�
- Scroll programs and change values in programming Mode
Speed hot keys:
Speed Hot Keys are set as: 6, 8 & 10 Km/h�
For example, the speed changes from any speed to 8 Km/h by
pressing the Speed Hot Key 8�
Mode
- Select program Mode�
- Confirm setting to enter next step in programming Mode�
- During workout Mode, change parameter for Speed/ Pulse &
Calories/ Incline window�
Manual
- Select the program Mode "Manual"(P-1) quickly�
Weight loss
- Select the program Mode "Weight loss "(P-2) quickly�
Interval
- Select the program Mode "Interval "(P-3) quickly�
Hill Climb
- Select the program Mode "Hill Climb "(P-4) quickly�
Walk
- Select the program Mode "Walk" (P-5) quickly�
Explanation of display items
Speed
- Shows the actual treadmill speed in workout Mode�
- Shows target speed in programming Mode�
Pulse
- Shows the pulse rate in workout Mode, or "P" when no pulse is
measured�
Distance
- Shows the ran distance workout Mode�
- Shows the target distance when being in programming Mode�
- Shows program selection when being in program Mode�
‼ NOTE
• This parameter will only count Up/ Down when walking/ running
on the treadmill� This is because of the build in movement
sensing system�
Time
- Shows the ran time in workout Mode�
- Shows the target time when being in programming Mode�
‼ NOTE
• If Time window shows "OIL" message, check section
"Lubrication" in this manual�
Calories
- Shows the consumed calories in workout Mode�
‼ NOTE
• This parameter will only count Up/ Down when walking/ running
on the treadmill� This is because of the build in movement
sensing system�
• This data is a rough guide for comparison of different exercise
sessions which cannot be used in medical treatment�
Incline
- Shows the actual treadmill incline in workout Mode�
- Shows target incline in programming Mode�
2 4