Do not use a faulty device. Keep the cord away from heated surfaces. J6 / J6F must not be used outdoors. J6 / J6F tolerates an environment measuring +10°C to +35°C. Air humidity must never exceed 90 %.
J6F: HAND RAIL AND INTERFACE (FIGURES 5, 6 AND 7) Turn the user interface until the holes for the locking screws are in position and then attach by tightening the 4 screws (M6x12) on the rear side. Cut the green ribbon of the hand rail.
Active trainer: 70-80 % of maximum heart-rate Exercise at this level suits only the fi ttest and presupposes long-endurance workouts. BEGINNING AN EXERCISE SESSION To avoid muscular pain and strain, begin and end each workout by stretching. Stand on the landing rails to the left and right of the running belt. Do not stand on the running belt.
Page 5
Lift motor fault or lifting motor overload protection off: Please switch the device off for 5 minutes and then restart. If the error message does not disappear, please contact your local Tunturi distributor. Remove the error code by pressing the RESET key. If any of these error codes appears repeatedly despite servicing, or if a code other than the above is displayed constantly, please contact your Tunturi dealer.
SET AND RESET :: In Set you can defi ne user weight, heart-rate alarm limits, audio signal use and units of measurement as follows: Press the Set key. Setting Set 1 (user weight) is displayed. Set the required value in the central display with the up/down setting.
CONTROL :: Standard heart-rate exercises enable training within a selected heart-rate level. Constant heart-rate exercise requires your using the heart-rate measurement system. Select the desired heart-rate mode by pressing the (indication light shows the selected mode): Speed (indication light <<<) = pulse control is based on changing belt speed.
50 hours of use. Use only T-Lube lubricant to lubricate the treadmill. Contact your local Tunturi distributor for further supplies of T-Lube. Attach the nozzle to the T-Lube container. Let the treadmill run at 5 km/h (3 mph).
16 :: MOVING AND STORAGE :: Before moving J6, be sure the power cord is unplugged from the wall and the treadmill. Lift the treadmill from the rear to an angle of about 30 degrees and push it on the front wheels. Lower the treadmill carefully onto the fl...
0 - 10 % Motor 1,8 HP (continuous duty) J6 / J6F treadmill meets the requirements of the EU's EMC Directives on electromagnetic compatibility (89/336/EEC) and electrical equipment designed for use within certain voltage limits (73/23/EEC). This product therefore carries the CE label.