Maintenance; Introduction; Terminology; General Procedures - Upright X Series Service & Parts Manual

Work platforms
Hide thumbs Also See for X Series:
Table of Contents

Advertisement

M
3.1 I
NTRODUCTION
Be sure to read, understand and follow all information in the Operation
Section of this manual before attempting to operate or perform service on
any work platform.
T
B
ERMINAL
LOCKS
W
C
IRE
OLOR
C
B
ONTACT
LOCKS
S
M
WITCH
OUNT
B
ASE
T
B
ERMINAL
LOCKS
3.2 D
C
ATE
ODE
G
ATES
P
ARKER
D
AYCO
X Series Work Platform
AINTENANCE
Reference: • Section 2 for recommended maintenance intervals.
W A R N I N G
!
NOTE: For Information on the engine refer to your local engine dealer.
This section contains instructions for the maintenance of the work platform. Procedures for the oper-
ation inspection, adjustment, scheduled maintenance, and repair/removal are included.
Referring to Section 2 will aid in understanding the operation and function of the various compo-
nents and systems of the work platform, and help in diagnosing and repair of the machine.
T
ERMINOLOGY
Located in upper and lower control boxes. Designated by TB##. (##) designates the number of the
block which is written on the terminal block. "R" (right) or "L" (left) may follow the number.
Indicated by color/color. First color refers to insulation color and second color indicates stripe. If sec-
ond color is not given, there is no stripe.
G
P
ENERAL
ROCEDURES
Removed by inserting a flat screwdriver into the slot at either end of the block and prying outward.
Installed by pressing into an empty slot.
Assembled to back of switch actuator. Removed by rotating the small black lever counterclockwise
and lifting off the base.
Remove wires by inserting a small flat bladed screwdriver into square beside the wire. Install wires
by stripping ½" of insulation, inserting screwdriver in square and inserting wire. Be sure no strands
are bent backwards. Replace wires with same rating and type.
I
DENTIFICATION ON
uses a five digit code: Year, Month, Day.
i.e.: 6 11 29 - means 1996, month 11 (November), day 29.
uses a ten digit code: Plant, Year, Month, Day.
i.e.: XXXX 6 11 29 - means Plant XXXX, 1996, month 11 (November), day 29.
stamps month, day and year on each hose.
!
H
OSES
060571-005
Page 3-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

X20nX20wX26nX31n

Table of Contents