Replacing Labeling Fields; Mounting Spacer In Case Of Compact Arrangement - Bosch Rexroth IndraControl S67 Application Description

DOK-CONTRL-S67HTLM12**-AP02-EN-P
Rexroth IndraControl S67 HTL Encoder/Counter Module 4 Digital Inputs/Outputs (4×M12)
5.7

Replacing Labeling Fields

5.8

Mounting Spacer in Case of Compact Arrangement

1. Disconnect the power supply from those devices on which the S67-HTL-
INC-M12 module is to be mounted.
2. Insert the two screws into the holes above and beneath the fastened
S67-HTL-INC-M12 module on the profile adapter.
3. Fasten an appropriate slot nut on each of these screws.
4. Insert the profile adapter with the attached S67-HTL-INC-M12 module
into the profile rail of the system. Position the profile adapter and tighten
the screws.
The module labeling plate and the labeling strip are provided upon delivery.
Remove the protective cover when labeling the labeling strip. Proceed as fol‐
lows:
1. Press the slot screwdriver (maximum slot width: 3 mm) into the small
opening under the labeling strip cover (12) and lever it up.
2. Remove the labeling strip cover.
3. Label the labeling strip with a waterproof pen.
4. Insert the labeling strip cover again and press it firmly in place.
If the module labeling card (10) is to be replaced, proceed the steps previous‐
ly described. New module labeling cards are available from Bosch Rexroth as
accessories.
10
Ch1.1
X
3
Ch1.2
X
1
Fig. 5-5: Replacing labeling fields
Using the spacer, a sufficient mounting distance can be achieved when di‐
rectly mounting the IndraControl S67 components. Gaps where dirt can accu‐
mulate are thus prevented. In addition, it is possible to optimize the cable
routing. Thus, two fastening lugs each for cable ties are located on the
spacer.
1. Disconnect the power supply from those devices on which the S67-HTL-
INC-M12 module is to be mounted.
Bosch Rexroth AG
HTL-INC
SB SB SB SB
F F
Ch2.1
12
X
4
Ch2.2
2
X
2
0
3
1
24V 24V 24V
U U U U
LS LS LS A A
33/85
Mounting Module