How To Install W Type(Wire) Link Units - Panasonic FP3 Technical Manual

2. How to Install W Type(Wire) Link Units

Before installing the units, remove the connector cover on the Master Backplane.
1 Fit the unit tabs into the unit holes on the Master Backplane.
Push the unit in the direction shown by arrow to plug it into the backplane.
Master
Backplane
Hole Tab
FP3 W type(Wire) Link Unit
2 After plugging the unit into the Master Backplane, tighten the installation screw at the
top and/or bottom.
FP3 W Type(Wire) Link Unit : at the top
FP5 W Type(Wire) Link Unit : at the top and bottom
Notes:
• Be sure to remove or install W Type(Wire) Link Units only when all power is OFF.
• Be careful not to use unreasonable force when plugging the connector on the W Type(Wire) Link
Unit into the connector on the Master Backplane.
Master
Backplane
Hole
Screwdriver
3-2.Installing W Type(Wire) Link Units
FP5 W type(Wire) Link Unit
Tab
19