Maintenance; Service And Repairs - Flex L 12-3 100 WET Instruction Manual

Instruction manual

MAINTENANCE

DANGER
Before performing any work on the
electric power tool, pull out the mains
plug.
! NOTE
Use only original parts supplied by the
manufacturer for replacement
purposes.
If non-original parts are used, the
guarantee obligations of the manu-
facturer will be deemed null and void.
KEEP TOOL CLEAN
Periodically blow out all air passages
with dry, compressed air. All plastic parts
should be cleaned with soft damp cloth.
NEVER use solvents to clean plastic
parts. They could possibly dissolve or
otherwise damage the material.
CAUTION
Wear safety glasses while using
compressed air.
FAILURE TO START
Should your tool fail to start, test the
GFCI, and check to make sure the
prongs on the cord plug are making good
contact in the outlet. Also, check for
blown fuses or open circuit breakers in
the line.
GEAR HOUSING
The gear housing should never be
loosened or opened, except by a FLEX
authorized service center. Doing so will
void the product warranty.
16
BRUSH INSPECTION AND
LUBRICATION
For your continued safety and electrical
protection, brush inspection and replace-
ment on this tool should ONLY be
performed by an authorized service
center for FLEX Power Tools.
At approximately 100 hours of use, take
or send your tool to your nearest
authorized service center for FLEX
!
Power Tools to be thoroughly cleaned
and inspected; worn parts replaced;
and when necessary, relubricated with
fresh lubricant if required; reassembled
with new brushes; and performance
tested.
Any loss of power before the above
maintenance check may indicate the
need for immediate servicing of your tool.
DO NOT CONTINUE TO OPERATE
TOOL UNDER THIS CONDITION. lf
proper operating voltage is present,
return your tool to a FLEX authorized
service center for immediate service.

SERVICE AND REPAIRS

All quality tools will eventually require
servicing or replacement of parts due to
wear from normal use. These opera-
tions, including brush inspection and
replacement, should ONLY be
performed by an authorized service
center for FLEX Power Tools.
To prevent injury, a damaged power cord
must be replaced by the manufacturer or
his customer service.
All repairs made by these agencies are
fully guaranteed against defective
material and workmanship. We cannot
guarantee repairs made or attempted by
anyone other than these agencies.
L/LE 12-3 100 WET