Flex L 12-3 100 WET Instruction Manual page 12

Instruction manual
5
2. Do not open shut-off valve until at
the place of use and the polishing
tool is rotating.
The volume of water can be regulated by
adjusting shut-off valve (Fig. 5).
8 6
Water will flow through spindle port
(Fig. 6).
! NOTE
Keep water flow to a minimum for the
operation and direct water flow away
from the tool and operator. DO NOT
use tool in a dry grinding or sanding
application. Doing so will generate heat
sufficient to damage the seals of the
water feed system.
12
ATTACHING OR CHANGING
THE POLISHING TOOL
Disconnect tool from power source.
7
1. Press spindle lock (1.).
2. Unscrew tool holder (2.).
8
!
3. Press spindle lock again (3.).
4. Screw on new tool holder (4.).
L/LE 12-3 100 WET
CAUTION