Advanced Netav Settings - Sony LocationFree LF-X11 Operating Instructions Manual

z
Tip
Distance from the Base Station, ambient radio wave
conditions, obstacles, and other factors can affect the
stability of a wireless network connection. When
setting up your computer, place it as close as possible
to the Base Station.
Notes
• When a connected computer is transferring data, the
TV picture on the Monitor may flicker or become
distorted.
• See "About Wireless Security" (1 page 5) for
information on wireless security.
• Not all wireless LAN devices can be guaranteed to
connect to the Base Station.
• You can connect a maximum of 15 wireless LAN
devices by using the Base Station as an access point.
In some cases, however, the number of connecting
devices may cause the communication speed to
decrease.
• For some wireless LAN devices, it may not be
possible to send and receive data smoothly if the
power save mode is enabled in the computer's
wireless LAN settings. In that case, check the
computer's wireless LAN settings, and disable the
power save mode. For details on these settings, refer
to the operating instructions for the wireless LAN
devices, such as your computer or wireless LAN
card.
74
Advanced NetAV
Settings
Normally these settings are not required when
you have performed [Easy Setup (NetAV)].
Configuring the LAN Settings
Required for Port Forwarding
If the router you are using is not compatible with
UPnP (Universal Plug and Play), port forwarding
is required. This section describes how to
configure the IP address manually.
1
Open the [Settings] window, and then select
[Base Station].
The [Base Station] window appears.
2
Select [Internet Connection].
The [Internet Connection] window appears.
[Internet Connection] can be selected when
the Monitor is in Home-Wireless mode. If
you cannot select [Internet Connection],
switch to Home-Wireless mode in the
[Monitor] window.
3
Clear the check from the [Automatic IP
Address Configuration (DHCP)] check box,
and then enter the addresses used in your
home LAN and select [Set].
Clear this check box.
[Back] [Set] Clear this check box.