Other Functions And Settings; Watching Tv/Video Via Wired Lan At Home - Sony LocationFree LF-X11 Operating Instructions Manual

Other Functions and Settings

Watching TV/Video
Via Wired LAN at
Home
You can watch TV and video with the
LocationFree TV "Home mode" via a wired
LAN, as well as via a wireless connection. To use
the wired LAN, you need to connect the Monitor
to the Ethernet port on a wall or on a router with
a LAN cable (not supplied).
The wired LAN connection is useful when video
stops frequently due to a poor wireless
connection and
screen.
To connect to a home LAN, use the following
procedure to make the necessary settings.
Monitor
z
Tip
Different IP addresses must be assigned to the Base
Station and the Monitor.
Setting Up the Monitor
The IP address is set beforehand to be assigned
automatically. Normally this does not need to be
changed, but you can follow the steps below to set
the IP address manually.
1
Open the [Settings] window and select
[Monitor].
The [Monitor] window appears.
60
appears at the top of the
Base station
2
Select [Settings] to the right of [Home-
Wired LAN].
The [Home-Wired LAN] window appears.
3
Select [Wired Monitor Settings].
The [Wired Monitor Settings] window
appears.
4
Clear the check from the [Automatic IP
Address Configuration (DHCP)] check box,
and then enter the address used in your home
LAN or the address supplied by your
Internet Service Provider (ISP), select [Set],
and select [Back].
Clear this check box.
[Back] [Set]
Notes
• Manually enter information provided by your
Internet Service Provider (ISP), such as IP
addresses. If the information you enter is
incorrect, the Monitor cannot connect to the
Internet.
• Do not enter the same IP address as the Base
Station. If you enter the same IP address, the
Monitor and Base Station are unable to
communicate and you cannot connect to the
Internet or watch TV or video.
The [Home-Wired LAN] window appears.
5
Select [Back].
The [Monitor] window reappears.
6
Select [Settings], and then select [Exit].