Sony LocationFree LF-X11 Operating Instructions Manual page 13

Base Station
Front
Rear
qf
qd
qs
1 WIRELESS LED
Indicates the wireless function status.
Blue: Connected with the Monitor on the 5 GHz channel.
Green: Connected with the Monitor on the 2.4 GHz channel.
Turns blue or green momentarily, then turns off for 3 seconds:
Wireless communications are enabled, but wireless
communication with the Monitor is not taking place.
1
2 NETWORK LED
Indicates the connection status to an external network, such as the
2
Internet.
Green blinking: Attempting to connect.
3
Green: Connected to the network. The LED blinks quickly when
4
data is transmitted.
Off: Not connected.
3 NETAV LED
5
Indicates the connection status with the LocationFree device.
Green quick blinking: NetAV authentication has failed.
Green slow blinking: Attempting to connect with NetAV.
6
Green: Connected with NetAV.
Umber blinking: Updating dynamic DNS.
Umber: Dynamic DNS failure.
Off: Not connected.
Red: The Base Station is being initialized.
4 SETUP MODE LED
Umber: The Base Station is in Setup mode.
Umber blinking: Registration of a LocationFree device is available.
5 POWER LED (1 page 21)
Green: The power is on.
Red blinking: A malfunction has occurred.
6 POWER button (1 page 21)
Turns the Base Station power on and off.
7 LAN port (1 page 19)
Connect a LAN cable (not supplied).
8 BASE STATION RESET button (1 page 81)
Initializes all settings on the Base Station to the factory defaults.
9 SETUP MODE button
Press to register the LocationFree devices, or to make the Base
Station settings without the Monitor.
7
0 IN 2 (AUDIO/VIDEO) terminal (1 page 16)
Connect audio and video cables.
8
qa DC IN jack (1 page 20)
9
Connect the AC power adapter (supplied).
qs VHF/UHF jack (1 page 15)
0
Connect an antenna cable (not supplied).
qd IN 1 (S-VIDEO/AUDIO/VIDEO) terminal (1 page 16)
Connect audio cables and either a video or S-video cable.
qf IR BLASTER port (1 page 17)
qa
Connect the IR Blaster (supplied).
Identifying Parts and Controls
13