Sony LocationFree LF-X11 Operating Instructions Manual page 47

home Base Station. Video appears shortly
after the icon appears.
See "Watching TV and Video" (1 page 31)
for information about TV and video
operations.
z
Tip
The NETAV LED on the Base Station lights
green while you are using the NetAV function.
Watching TV and videos with NetAV
You can change channels and adjust the volume
in the same way that you do while watching at
home. For details, see "Watching TV and Video"
(1 page 31).
Also, if you connect the supplied IR Blaster, you
can control your home video equipment by using
an on-screen remote control.
z
Tips
• It may not be possible to view some kinds of copy-
protected material.
• When you change channels while using NetAV, it
could take some time before the picture appears.
To change the TV screen size
You can change the TV screen size by selecting
[Resize]. Each selection changes to the next size,
in three steps. At the time of purchase, the
Monitor is set up to display a full screen.
[Resize]
z
Tip
At some connection speeds, a full-screen picture may
be rough. A smoother picture may be shown by
selecting a smaller screen size.
To change the streaming rate
You can adjust the streaming rate according to the
bandwidth available on your network connection.
This allows you to watch TV or video with the
optimum quality.
Normally, selecting [Auto] sets the optimal video
rate in accordance with available bandwidth.
When selecting a rate manually, note that a higher
(larger number) rate results in higher picture
quality, but a higher rate requires a larger
bandwidth and video will tend to keep stopping
and starting if there is insufficient bandwidth for
the higher rate.
1
Select [Rate].
The rate setting window appears.
2
Select [Auto] or [Manual].
The optimum rate is set automatically when
you select [Auto].
If you select [Manual], choose the rate from
among 6 steps.
Select a speed.
Note
When you switch between [Auto] and [Manual],
change the rate from [1] or [6] to another rate, or
change from another rate to [1] or [6] while
connected, NetAV is disconnected and then
reconnected automatically.
3
Select [OK].
You can change the rate even while you are
not using NetAV.
To quit NetAV
Select [End] at the bottom of the window.
[OK]
47