Takara Belmont RS III Operating Manual page 36

Procedures for Daily Inspections (Continued)
To ensure that this product can be used for a long period of time, conduct the inspections below.
Inspection item
Does the thermostatic
□
control knob work
properly?
Can the basin be filled
□
with water?
■Items that must be inspected after closing for the day
Inspection item
Is the drain blocked?
□
Has the tap been
□
turned firmly?
Inspection item
□ Is there any water
leaking within the
basin?
Is there are any
□
limescale or dirt
blocking the spray
nozzle?
Inspection method
Turn the thermostatic control knob,
□
check that the water temperature is
adjusted properly and that there is
no abnormal noise.* An abnormal
gushing sound may be emitted as
water flows. (see page 17)
□Check that the drain cap can be used
to block the drain and that water
filling the basin does not drain.
Inspection method
Check that the drain is not blocked
□
with the drain cap, towel or
shampoo cloth.
Turn the tap firmly in a clockwise
□
direction and check that the water
turns off properly.
■Items that must be inspected once each week
Inspection method
□ Remove the basin maintenance
cover and check that there is no
water leaking from the internal
pipes or water taps (see page 25,
26).
□Remove the spray nozzle from the
shower head and check that there is
no limescale or dirt on it (see page
23, 24).
If the inspection results show defects
If the water temperature cannot be adjusted
□
properly or if there is abnormal noise, there may
be a problem with the thermostatic control within
the basin. Stop using the product immediately.
□When the water decreases quickly, there is a
possibility that the drain cap gasket has
deteriorated. The drain cap gasket is a
consumable part. Immediately replace it. (See
page 22.)
If the inspection results show defects
Remove the object that is blocking the drain. If the
□
drain is blocked, water that is turned on
accidentally or a slight trickle of water due to an
increase in water pressure at night may cause
water to spill from the basin, leading to water
leakage.
Turn the tap firmly and turn the water off properly.
□
If the water does not turn off completely, there may
be a malfunction in the stop valves of the tap.
Close the stop valves in the water supply pipe and
hot water supply pipe (see page 25, 26), and stop
using the product immediately.
If the inspection results show defects
□ If water is leaking from the pipes, the pipes or
gasket may be worn, degraded or damaged. Close
the stop valves in the water supply pipe and hot
water supply pipe (see page 25, 26), and stop
using the product immediately.
Use an item such as a toothbrush to remove any
□
dirt such as limescale and clean the spray nozzle.
Leaving the spray nozzle uncleaned will lead to
blockage, and water may not be output from the
shower head properly.
TAKARA BELMONT CORPORATION
1-1, 2-Chome, Higashi-shinsaibashi,Chuo-ku,Osaka,Japan
TEL : +81-6-6213-5945
36
FAX : +81-6-6212-3680
Printed in Japan
1E02VXA0