Takara Belmont RS III Operating Manual page 24

2
Rotate and loosen the air bubble fixture with the wrench.
3
Remove the three parts (rubber gasket, air bubble unit, and
air bubble fixture) and wash with water using a nylon or
similar brush.
The air bubble unit should be rinsed with running water
in the direction shown in the illustration below:
Running Water
4
After cleaning, set the three parts in the order shown in the
illustration.
5
Tighten the air bubble fixture with the wrench.
This completes the cleaning.
The air bubble unit and the gasket can be reused after washing
with water. If replacements are required due to deterioration or
breakage, however, contact your closest dealer.
<Dual Function Shower Head>
1
Rotate and detach the shower head plate and remove the
three parts (shower head plate, air bubble unit, and rubber
gasket).
（※Do not detach the O-ring.)
2
Clean the shower head plate (with water).
・ Remove dirt, such as water deposits in the shower holes
on the shower head plate, with a toothbrush.
3
Clean the air bubble unit (with water).
・ Clean the unit once a month (as a general guide).
・ Remove dirt, such as water deposits on the air bubble
unit, with a toothbrush.
The air bubble unit should be rinsed with running water
in the direction shown in the illustration below:
Running Water
4
Re-assemble the shower head.
<Assembling Procedures>
(1) Insert the air bubble unit and the rubber gasket in
the shower head plate in this order.
(2) Mount the shower head plate on the shower head
main unit, while the water discharge side of the
shower head plate facing down.
Air Bubble Unit
Air Bubble Unit
24
Rubber Gasket
O-ring
Rubber Gasket
Shower Head Plate
Surface to be Cleaned
(front and back)
①
Loosening
Tightening
Air Bubble Fixture
Air Bubble Unit
Shower Head Main Unit
Air Bubble Unit
②
Water Discharge Side