Takara Belmont RS III Operating Manual page 18

■Adjusting the water temperature
1
Turn the thermostatic control knob in the H or C direction to set the
temperature to an appropriate level.
When adjusting the water temperature, reduce the
volume of water, point the shower head away from
Caution
the customer and check the temperature by hand.
Take care when doing so, as hot water may come
out of the shower head.
2
To use hot water turn the thermostatic control knob in
the H direction while holding down the stop button.
Return the knob to an appropriate position after use.
Using other equipment that share the same water/hot water supply source at the same time
Caution
Operate the thermostatic control knob only after removing metallic objects, such as rings and
Before using the product, check that there are no scratches, cracks, or peeling of the plated
* For safety reasons, this product is designed so that hot water of approximately 53℃ or higher is not output.
(Conditions: At the same supply pressure, normal water temperature is 20℃ and hot water temperature is 60℃)
The water discharge amount may change significantly when controlling the hot water temperature
depending on the operating environment or conditions. This phenomena occurs when the hot
water temperature exceeds the recommended values (60℃ to 80℃), there is significant difference
in the water supply or hot-water supply pressure, or multiple devices are used at the same time-it
is not equipment failure.
The temperature of discharged water and the preset temperature may differ depending on the
operating environment or conditions.
Note
(The system is designed so that the temperature of the discharged water will be about 40℃ when
the thermostatic control knob is rotated toward the H position and locked in that position.)
This phenomena occurs when the hot water temperature exceeds the recommended values
(60℃ to 80℃), there is significant difference in the water supply or hot-water supply pressure,
or multiple devices are used at the same time it is not equipment failure. The temperature of
discharged water may be set at about 40℃ when the temperature of hot water or the pressure of
the water/hot water supply is adjusted and the locking position of the thermostatic control knob is
adjusted. When you want to order an adjustment from us, contact your closest dealer.
(excluding AY-P073X,AY-074X)
Continuing to use the hot water with the knob in the hot position may cause burns.
may cause unstable water temperature.
Do not execute any quick operation of the respective devices.
wristwatches. Failure to take this precaution may result in contact between the metal and the
thermostatic control knob resulting in scratches or cracks on the plated surface and thereby
causing peeling of the plating.
surface of the thermostatic control knob. If the plating is peeled off, immediately stop using
the product and contact your closest dealer. Continued operation may result in personal injury.
(C) Cold
18
(H) Hot
Thermostatic
control knob
Stop button