Front Panel USB Connector Selection: FNT_USB
The 6-pin block jumper provides you with the capability to enable the USB
connector on the front panel if you need to connect your USB devices with
your computer system via front panel instead of back panel.
2). Install RAM Modules
RAM Module Configuration
This mainboard provides two onboard DIMM sockets for allowing 3.3V (un-
buffered) SDRAM DIMM modules. Either 8, 16, 32, 64, 128, 256MB DIMM can
be installed on these two sockets. The maximum total memory supported is up
to512MB.
NOTE: This mainboard supports DIMMs with access speeds of
12ns, 10ns, or faster. ECC memory and parity check is also sup-
ported.
Installation Procedures
2 - 11