Table of Contents
Advertisement
Process
Input
The Process Input (Single & Dual) accept up to two 0-24 mA, 0-0.1 V
these features, change the Input Type selection to Single Process or Dual Process and then choose the Device
Range/Type option in the side bar.
Note:
When using Dual Process, the Device Range/Type section is only available for Input 0. Input 1 is always the
same type as Input 0.
Warning:
Be sure to setup the unit before plugging in Process inputs.
Rear view of Filed Connector Shown
RTD
Input
The RTD Input interface provides interfaces to type 100, 500, and 1000 ohm 385 Curve, 100 ohm 392 Curve, and 100
ohm 3916 Curve RTD devices in 2, 3 and 4 wire configurations. A single RTD connection is supported.
To use these features, change the input type to RTD using SYNC.
Pin 1
Pin 2
Pin 3
Pin 4
Figure 33
, 0-1.0 V
DC
Figure 32
Voltage
Current
Input 1
Input 1
Input 2
Input 2
Ground 2
Ground 2
Ground 1
Ground 1
Figure 34
, or 0-10 V
process inputs. To use
DC
DC
19 |
P a g e
Advertisement
Table of Contents
