Table of Contents
Advertisement
Viewing Data on the ZW-REC Page
Once your XW Transmitter has been successfully connected to your ZW-REC,
you will be able to view the transmitter on the ZW-REC webpage.
You may navigate to the ZW-REC webpage through SYNC by clicking the
Home Page button as seen in Figure 20.
Alternatively, you may navigate to the ZW-REC webpage by typing the
ZW-REC IP Address into your web browser.
8-pin digital probes, including Omega Smart Probes that have already been
connected, will transmit readings to the ZW-REC webpage. See Figure 21.
To configure Digital I/O, Analog connections, or view wiring diagrams of the XW
Transmitters, proceed through this manual to find the relevant connection type.
XW-ED Wiring
The XW-ED is a versatile transmitter that can accept a wide variety of digital probes, function as a rate/timer/totalizer, or as
an mA/mV meter.
Digital Probes
The XW-ED is configured to use digital probes by default. Simply attach your probe to the 8-Pin M12 connector and the
XW-ED will automatically connect it. SYNC can then be used to setup smart probe specific options. Please refer to your
smart probe User's Manual for more details.
Note:
Probes should be connected to the XW-ED before starting SYNC. If you have a Probe with Digital I/O
connected to an XW-ED-PRO, the Probe Digital I/O will show up before the XW-ED-PRO Digital I/O in SYNC and on
the ZW-REC Web interface.
Figure 21
Figure 20
14 |
P a g e
Advertisement
Table of Contents
