Table of Contents
Advertisement
Connecting to SYNC – Auto Detect
Before you begin, ensure your XW Transmitter and ZW-REC are connected to the computer running SYNC.
Step 1:
Once the XW Transmitter is connected via Micro USB cable and is auto-detected, click Next.
Note:
If SYNC does not auto-detect the XW Transmitter, click
Step 2:
SYNC will detect the Network ID of the previously connected ZW-REC (Default is 0). Click Next.
Note:
The Network ID is a unique identification number that allows a device to be identified within a network. In
the case of having multiple ZW-RECs, you will have to choose which ZW-REC you would like to connect to by
selecting the Network ID of your preferred ZW-REC.
Step 3:
Assign a unique Device ID to your XW Transmitter.
Note:
The Device ID is a specific number (between 0 and 127) assigned to your XW-ED that will identify this device
to the receiver it was assigned to.
Step 4:
Assign a device name to your XW Transmitter.
Step 5:
Review your selections and click Finish.
The blue LED will begin to flash quickly and turn off to display that a connection was successfully established. The LED will
flash again each time a new reading is transmitted.
Note:
If you have successfully connected your XW Transmitter to SYNC, skip ahead to section Viewing Your
Transmitter.
Figure 13
Figure 15
to search for connected devices.
Figure 14
Figure 16
11 |
P a g e
Advertisement
Table of Contents
