Process Input
The XW-ED can also accept up to two 0-24 mA or 0-1.0 V
from the Type selection and then choose the Device Range/Type option in the side bar.
Note:
When using Dual Process, the Device Range/Type section is only available for Input 0. Input 1 is always the
same type as Input 0.
Warning:
Be sure to setup the unit before plugging in Process inputs.
Figure 29
Rear view of Filed Connector Shown
process inputs. Select either Single Process or Dual Process
DC
Figure 28
Frequency, Pulse
Width, Duty Cycle
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
3.3V Output
NC
Input 1
Input 0
NC
Shield
NC
GND
17 |
P a g e