Can-Am MAVERICK Sport MAX Series Operator's Manual page 103

– Riding on dry gravel trails or similar
conditions.
– Riding in areas with high concentra-
tion of seeds or crop husks.
– Riding in severe snow conditions.
NOTICE
When riding in dusty con-
ditions or sand, the air box needs to
be cleaned before every ride.
NOTE: Riding in a group under these
conditions would increase even more
the air filter replacement frequency.
Engine Air Filter Removal
Remove side access cover by un-
screwing the quarter turn fasteners.
219001880-025_a
1. Quarter turn fasteners
Unlatch air filter cover and remove air
filter.
219002003-026
TYPICAL - RH SIDE OF VEHICLE, UNDER
CARGO BOX
1. Air filter cover
2. Latches
3. Duck bill valve
The filter fits tightly over the outlet
tube and there will be some initial re-
sistance. Gently move the end of the
filter back and forth to break the seal,
then rotate while pulling straight out.
Avoid knocking the filter against the
housing.
Engine Air Filter Cleaning
Inspect the filter for any signs of leaks.
A streak of dust on the clean side of
the filter is a telltale sign. Replace filter
if there is any damages. Eliminate any
source of air leaks before installing a
new filter.
Clean engine air filter by tapping out
heavy dust from paper element, this
will allow dirt and dust to get out of the
paper filter.
NOTICE
blow compressed air on the paper
element; this could damage the pa-
per fibers and reduce its filtration
ability when used in dusty environ-
ments. If engine air filter is too dirty
and cannot be cleaned following the
recommended procedure, it should
be replaced.
Use a clean damp cloth to wipe both
the filter sealing surface and the inside
of the outlet tube. Ensure that the out-
let tube sealing area is undamaged.
Inspect air filter housing for cleanli-
ness.
Duckbill Valve Cleaning
Visually check and physically squeeze
the duckbill valve. Make sure the valve
is flexible and not inverted, damaged
or plugged.
Engine Air Filter Installation
Insert the filter carefully. Seat the filter
by hand, making certain it is inserted
completely into the air cleaner hous-
ing. Apply pressure by hand at the
outer rim of the filter, not the flexible
center.
______________
MAINTENANCE PROCEDURES
It is not recommended to
101