Can-Am MAVERICK Sport MAX Series Operator's Manual page 106

MAINTENANCE PROCEDURES
1. Full
2. Add
To add oil, remove the dipstick. Place a
funnel into the dipstick hole.
Add a small amount of recommended
oil and recheck oil level.
Repeat the above procedures until
oil level reaches the dipstick's upper
mark.
NOTICE
Do not overfill. Wipe off
any spillage.
Properly tighten dipstick.
Recommended Engine Oil
Rotax ® engines were developed and
validated using the XPS™ oil. BRP rec-
ommends the use of its XPS engine oil
or an equivalent at all time. Damages
caused by the use of an oil not suitable
for the engine may not be covered by
the BRP Limited Warranty.
______________
104
XPS RECOMMENDED ENGINE OIL
Scandinavia:
4T 5W40 SYNTHETIC
BLEND OIL (EUR)
(P/N 779290)
General
purpose Other Countries:
4T 5W40 SYNTHETIC
BLEND OIL
(P/N 779133)
Scandinavia:
4T 0W40 SYNTHETIC
OIL (EUR)
Cold
(P/N 779286)
temperature
Other Countries:
4T 0W40 SYNTHETIC
OIL (P/N 779139)
Scandinavia:
4T 10W50
SYNTHETIC OIL
Warm
(EUR) (P/N 779240)
temperature
Other Countries:
4T 10W50 SYNTHETIC
OIL (P/N 779234)
IF THE RECOMMENDED XPS
ENGINE OIL IS NOT AVAILABLE
Use a 4-stroke SAE engine oil
meeting or exceeding the following
lubricant industry specifications.
Always check the API service label
certification on the oil container, it must
contain at least one of the indicated
standards.
– API service classification SJ, SL,
SM or SN
Engine Oil Change
Place vehicle on a level surface.
NOTE: Oil change and oil filter replace-
ment should be done with a warm en-
gine.
CAUTION The engine oil can
be very hot. Wait until engine oil is
warm.
Place a drain pan under the engine
drain plug area.