Removable Anti Glare Shield - BVM GO FLY GOLD F-86 Sabre Assembly And Operating Manual

Removable Anti Glare Shield

This is an option, but it does make it
easier to get to your RX batteries in
the nose.
Using a ½ wide piece of Masking
Tape. Lay the tape against the side of
the Glare Shield and cut off the
remaining portion exposed. This will
help to get it past the flange of the
fuselage.
Once trimmed it will look like this in
the photo.
Using the supplied 6 inch hard Balsa
cut a piece to span across the inside
opening of the Anti Glare Shield.
Next use (2) Servo Screws to hold the
balsa block to the Cockpit Tub.
Next leave a ½ space between the
Top of the Cockpit Deck and the
Bottom of the Anti Glare Shield. And
tack the glare shield to the Balsa
Block. Use QT Poxy to glue the
block.
BVM ® 2020
F-86 Sabre
Assembly & Operation Manual
14