Site Requirements; Printer Dimensions; Single-Hopper Printer - Entrust EM1 Installation And Administrator's Manual

Direct to card printers
Hide thumbs Also See for EM1:
Table of Contents

Advertisement

Site Requirements

Set up and use the printer in an environment that meets the following requirements.
Use a single-phase, 3-wire, grounded receptacle.

Place the system and its supplies in a clean office environment, keeping paper and foreign

materials off of the equipment.
Place the printer on a sturdy, level surface.

Place the printer away from direct sunlight.

Do not place the printer near heating ducts, fans, or other air vents.

Do not use the printer for purposes other than the intended use.

Provide space for the printer and for clearance around the printer. The printer dimensions

and clearance area are shown in the following sections.

Printer Dimensions

The external printer dimensions are shown in the following illustrations.

Single-Hopper Printer

EM1 and EM2 Card Printer Installation and Administrator's Guide
9.0 in
229 mm
8.9 in
226 mm
17.4 in
442 mm
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EM1 and is the answer not in the manual?

This manual is also suitable for:

Em2

Table of Contents