Table of Contents
Advertisement
Chapter 3 - Initial Configuration
3.3.2
Basic Parameters
There are only a few basic steps you need to set up the SU-A-EZ and provide a
connection to your service provider's Access Unit.
Follow these steps:
Set a New Password – On the Wireless Client Setting page, enter a new
1
password to replace the default "private".
NOTE
It is strongly recommended that you configure your own password. If a password is not configured,
the management interface is not protected and anyone that can connect to the SU-A-EZ may be
able to compromise your network security.
Set the ESSID (Extended Service Set Identifier) – Enter the SSID, or wireless
2
network name, of the network you want to connect to. All SU-A-EZs in the
same network must use the same SSID as the remote access point to
associate. The SSID is case sensitive and can consist of up to 31 alphanumeric
characters.
Enter WEP Keys – If the wireless network you are connecting to uses WEP
3
security, you need to enter the WEP key provided to you by the network
operator. Enter "0x" followed by 32 hexadecimal digits (0 to 9 and A to F) for
152 bit keys. Note that Authentication Algorithm, Data encryption, Default key
and all 4 keys (or at least the one selected as the default) must be configured
36
Figure 3-3: The SU-A-EZ Management Interface
Commissioning
Advertisement
Table of Contents
