Table of Contents
Advertisement
Chapter 5 - Command Line Interface
Example 2
Installer# get BSSList apmac
apmac
00:10:e7:24:0d:9a
Installer#
5.9.13 set CStatus clear-cnt yes
This command sets all Rx/Tx statistics to a null value.
Syntax
set CStatus clear-cnt yes
Default Setting
None
Command Mode
Installer, Admin
Example
Installer# set CStatus clear-cnt yes
Installer#
5.9.14 get CStatus
This command displays the status of the wireless interface, as well as some
Ethernet statistics.
Syntax
get CStatus
get CStatus <essid | apmac | channel | freq | linkquality | rssi | noisefloor |
txpower | linkstatus | rxpkt-wlan | rxbyte-wlan | txpkt-wlan | txbyte-wlan |
rxpkt-eth | rxbyte-eth | txpkt-eth | txbyte-eth | iface>
• essid - The service set identifier that is attached to packets sent from the SU-A-EZ.
• apmac - The physical layer address used to uniquely identify the AP.
• channel - The radio channel through which the SU-A-EZ communicates with the AP.
• freq - The portion of the 802.11a frequency band the SU-A-EZ is using.
• linkquality - A measurement of the quality of the signal received by the SU-A-EZ.
• rssi - A measure of the received signal strength indicator for the AP.
• noisefloor - A level of interference below which signals to and from the SU-A-EZ cannot
be detected.
• txpower - A measure of the transmission signal power.
• linkstatus - A measure of activity on the link between the SU-A-EZ and associated AP.
• rxpkt-wlan - A measurement of the number of wireless packets received by the
SU-A-EZ.
• rxbyte-wlan - A measurement of the number of wireless bytes received by the SU-A-EZ.
• txpkt-wlan - A measurement of the number of wireless packets transmitted by the
SU-A-EZ.
• txbyte-wlan - A measurement of the number of wireless bytes transmitted by the
SU-A-EZ.
• rxpkt-eth - A measurement of the number of packets received by the SU-A-EZ over the
Ethernet port.
90
Operation
Advertisement
Table of Contents
