Adjusting The Contractor Level (Contractors Only) - Bosch FR 10 Installation And Operating Instructions Manual

|
126 Operation
5.4 Adjusting the contractor level (contractors
only)
The contractor level is the exclusive domain of
contractors.
B Accessing contractor level: Hold down mode for approx. 6
seconds until – – – is displayed.
B Release the mode key and turn
parameter is shown:
– 5A p = Code
– 5b p = Heating circuit configuration
– 6A p = Calibrate the integral room temperature sensor
– 6b p = Calibration factor I
– 6C p = Amplification factor V
– 6d p = Maximum flow temperature
– 6E p = Mixer runtime
B Briefly press
selected parameter is displayed.
B Briefly press
B Turn
B Briefly press
B Press mode until the current room temperature is displayed.
: The current value for the previously
: The current value flashes.
to select the required value.
to save the value.
until the required
6 720 645 356 (2010/09)