Sensor Only Mode; Adjustable Remote Mode; Time Period - Bosch TSTBM-RRS--TW-A Installation Manual

Remote temperature sensor
Table of Contents

Advertisement

Remote Sensor Confi guration
Go to page 6 of this manual to see the
instructions on how to connect the
TSTBM-RRS--TW-A to the
TSTBM3H2CPH6W-A Master
Thermostat.
Tech setup cannot be entered if the
TSTBM-RRS--TW-A is in temporary hold
mode. Press the RUN key to exit
temporary hold.

sensOr Only MODe

(shOW seT tech screen set to n)
In sensor only mode (set to N) the remote will not
allow you to change the set point. The current
ambient temperature will be displayed and
transmitted to the TSTBM3H2CPH6W-A every fi ve
minutes. The ambient temperature will be used for
controlling when system average is selected and
whenever it is given priority by the program in the
TSTBM3H2CPH6W-A.
TsTbM-rrs--TW-a
show set Tech set up screen

aDJusTable reMOTe MODe

(shOW seT tech screen set to y)
In show set mode it will show the temperature
setpoint arrows and the CLEAN key.
In this mode the TSTBM-RRS--TW-A can be used to
override the TSTBM3H2CPH6W-A current settings
for 4 hours in addition to being used as temperature
sensor.
Revised 02-13
Caution
Caution
Caution
Subject to change without prior notice
TsTbM-rrs--TW-a
TsTbM-rrs--TW-a
show set Tech set up screen
The TSTBM-RRS--TW-A will show the Run
key for 4 hours even if the
TSTBM3H2CPH6W-A is put back in to
normal operation or overridden by a 2nd
remote. However, the last device changed
will have priority.
The last remote or master
changed will have priority.
There is no permanent hold on the TSTBM-
RRS--TW-A , but you can select
a permanent hold from the
TSTBM3H2CPH6W-A.
programming a priority for the sleep

time period

In this example system we have one
TSTBM3H2CPH6W-A on the main fl oor and one
TSTBM-RRS--TW-A in the Master Bedroom on the
2nd fl oor. During the setup process the
TSTBM-RRS--TW-A was named Bedroom 1. During
Wake, leaVe and reTurn, the program should
remain on system average. When on the sleep time
period during programming, press neXT ZOne until
Bedroom 1 shows. During the sleep time period
the other remotes in the house will be ignored and
the system will be controlled only by the ambient
temperature of the TSTBM-RRS--TW-A in the master
bedroom. The Wake, leaVe and reTurn
temperature will be controlled by the system
average.
6 720 220 377
9

Advertisement

Table of Contents
loading

Table of Contents