Load Fail-Safe Defaults; Load Setup Defaults; Set Supervisor/User Password; Save & Exit Setup - Intel Xeon E7500 User Manual

BIOS SETUP

Load Fail-Safe Defaults

This option allows you to load the troubleshooting default values
permanently stored in the BIOS ROM. These default settings are
non-optimal and disable all high-performance features.

Load Setup Defaults

This option allows you to load the default values to your system
configuration. These default settings are optimal and enable all high
performance features.

Set Supervisor/User Password

These two options set the system password. Supervisor Password sets a
password that will be used to protect the system and Setup utility. User
Password sets a password that will be used exclusively on the system. To
specify a password, highlight the type you want and press <Enter>. The
Enter Password: message prompts on the screen. Type the password, up
to eight characters in length, and press <Enter>. The system confirms
your password by asking you to type it again. After setting a password, the
screen automatically returns to the main screen.
To disable a password, just press the <Enter> key when you are prompted
to enter the password. A message will confirm the password to be
disabled. Once the password is disabled, the system will boot and you can
enter Setup freely.
Save & Exit Setup
This option allows you to determine whether or not to accept the
modifications. If you type "Y", you will quit the setup utility and save all
changes into the CMOS memory. If you type "N", you will return to Setup
utility.

Exit Without Saving

Select this option to exit the Setup utility without saving the changes you
have made in this session. Typing "Y" will quit the Setup utility without
saving the modifications. Typing "N" will return you to Setup utility.
40 IB900 User' s Manual