Set Initial Position; Set Scheduled Tasks - HIKVISION DS-2TD6237-50H4L/W User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Note
Scan limit is only supported by the device that has scan function.
3. Click Set and set limits according to the prompt on the live image.
4. Optional: Click Clear to clear the limit settings of the selected mode.
5. Click Save.
6. Check Enable Limit.
Note
If you need to cancal all the set patrol paths, go to Configuration → PTZ → Clear Config , select
Clear All PTZ Limited, and click Save.
Result
The device can only move within the set region after saving the settings.

8.7 Set Initial Position

Initial position refers to the relative initial position of the device azimuth. You can set the initial
position if you need to select one point in the scene as the base point.
Steps
1. Go to Configuration → PTZ → Initial Position .
2. Move the device to the needed position by manually controlling the PTZ control buttons.
3. Click Set to save the information of initial position.
Call The device moves to the set initial position.
Clear Clear the set initial position.

8.8 Set Scheduled Tasks

You can set the device to perform a certain task during a certain period.
Steps
1. Go to Configuration → PTZ → Scheduled Tasks .
2. Check Enable Scheduled Task.
3. Select the a task type from the drop-down list and draw a time bar on the schedule table.
4. Click the set time bar and set the action ID and smart event or VCA type.
Note
Not all task types support the settings of action ID and smart event or VCA function. Please take
the actual product for reference.
5. Repeat step 3 and step 4 to set more than one scheduled tasks.
42