Advanced Configuration - HIKVISION DS-2TD6237-50H4L/W User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
The schedule for the channels can not overlap.
3. Click Save.

5.4 Advanced Configuration

Go to Configuration → VCA → Advanced Configuration and configure the parameters.
Detection Parameters
Detection Sensitivity
The higher the sensitivity is, the easier the target will be detected.
Background Update Rate
if a detected target remains in the monitoring scene for a certain time, the system will count the
target as the background automatically. The greater the value is, the faster the target will be
counted as the background.
Minimum Target Size
The system will filter out the object smaller than the minimum target size.
Displacement Constraint for Target Generation
The higher the value is, the slower the target is generated, and the higher accuracy the analysis
will get.
Optical-axis Movement
Check the function when the target moves in the direction of camera's optical -axis.
When the target is far from the device and the movement is not clear, enable this function to
check the move direction.
Single Alarm
The system only sends alarm once for one target triggering. Otherwise, the alarm will be
triggered continuously until the target disappears.
Scene Modes
The scene mode is set to be General by default. Select Distant View when you are far from the
targets. Select Leaves Interfered View when there are shaking targets in the scene, such as
leaves.
Restore Parameters
Restore Default
Click Restore to restore the parameters to the default.
Restart VCA
Click Restartto restart the VCA function.
Note
25