Table of Contents
Advertisement
Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
4. Click OK to finish a patrol setting.
5. Repeat the steps above to configure multiple patrols.
6. Operate patrols.
Call the patrol.
Stop patroling.
Delete the patrol.
Set the patrol.
Note
You can delete all patrols in Configuration → PTZ → Clear Config . Click Clear All Patrols, and
click Save.
8.3.1 Set One-Touch Patrol
The device automatically adds presets to one patrol path and starts patrol scan.
Steps
1. Set two or more presets except special presets. For setting presets, refer to Set Preset .
The device will automatically add presets to patrol path No.8.
2. Choose one of the following methods to enable the function.
- Click
.
- Call patrol path No.8.
- Select and call preset No.45.
8.4 Set Pattern Scan
The device can move as the recorded pattern.
Steps
1. Click to show the PTZ control panel, and click
2. Select one pattern scan path that needs to be set.
3. Click
to start recording pattern scan.
4. Click PTZ control buttons as demands.
Note
Recording stops when the space for pattern scan is 0%.
5. Click
to complete one pattern scan path settings.
6. Click
to call pattern scan.
Stop pattern scan.
.
40
Advertisement
Table of Contents
