Related Manuals for Da-Lite DESIGNER ELECTROL
Summary of Contents for Da-Lite DESIGNER ELECTROL
- Page 1 ELECTROL INSTRUCTION BOOK FOR DESIGNER ELECTROL DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 219/267-8101 800-622-3737 Fax: 219/267-7804 http:// www.da-lite.com e-mail: info@da-lite.com...
-
Page 2: Pre-Installation
PRE-INSTALLATION Before proceeding with the installation of the screen, please read the installation and operations instructions thoroughly! CAUTION! Do not cut wrapping paper or tape with knife or any sharp tool. Remove by hand. 1. Carefully unpack the screen and remove the outer wrapping. 2. -
Page 3: Screen Adjustment
SCREEN ADJUSTMENT The screen surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at the factory. The screen should not be adjusted for more or less drop. Should the picture surface get out of adjustment and it be necessary to adjust picture surface drop, proceed in the follow- ing manner. - Page 4 DESIGNER ELECTROL INSTALLATION 120V WIRING DIAGRAM MOTOR EXTERNAL WIRING TO BE COMPLETED TO JUNCTION BOX MOUNTED IN BY INSTALLER. SCREEN CASE, IN WHICH INTERNAL WIRING TERMINATES IN WHITE, BLACK AND RED LEADS. SIDE VIEW DOWN WHITE LIMIT SWITCH KNOB OF SWITCH...
-
Page 5: Troubleshooting
TROUBLESHOOTING SYMPTOM CAUSE SOLUTION (a) Replace fuse. 1. Screen will not operate or will (a) Blown fuse. not go “down”. (b) Tripped power supply circuit breaker. (b) Reset circuit breaker. Motor does not hum. (c) No power to operating switch or (c) Check above. - Page 6 Da-Lite personnel. Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise. Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
Need help?
Do you have a question about the DESIGNER ELECTROL and is the answer not in the manual?
Questions and answers