Da-Lite Tensioned Executive Electrol Instruction Book
Hide thumbs
Also See for Tensioned Executive Electrol:
- Specification (2 pages) ,
- Instruction book (8 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Da-Lite Tensioned Executive Electrol
Summary of Contents for Da-Lite Tensioned Executive Electrol
- Page 1 INSTRUCTION BOOK FOR Tensioned Executive Electrol...
-
Page 2: Important Safety Instructions
Important Safety Instructions Pre-Installation When using your video equipment, basic safety precautions should 1. Carefully unpack screen and remove outer wrapping always be followed, including the following: from case. Read and understand all instructions before using. 2. Remove instructions cover and please read instructions. -
Page 3: Access Door Installation
The picture surface drop, and the opening and closing of the fabric door, are controlled automatically by limit switches which have been preset at Da-Lite. When the picture surface is moving upward, it is controlled by a limit switch that shuts off when the door closes. The height for tensioned screens are adjusted at Da-Lite, changing the height of screen will change the tension on fabric and cause the screen to hang improperly. - Page 4 Tensioned Executive Electrol Installation ® Suggested Methods of Installation Type 1 & 2 Type 1 & 2 Offset mounting, recessed above ceiling, for plaster, Allow 1⁄8" min. clearance all around surface door. dry wall or paneling. Door painted same finish as ceiling.
- Page 5 This Switch Cannot Be Used With L. V .C. 240 Volt Wiring Diagram For Standard Wall Switch: Da-Lite offers two styles of 240 volt wall switches for standard operation. Please see wiring diagram included in wall switch box included with screen.
-
Page 6: Troubleshooting
Troubleshooting Visit www.da-lite.com/products/tutorials.php to find installation by email at info@da-lite.com or by phone at (800) 622-3737 or and troubleshooting tutorials. You will also find a link to (574) 267-8101 with any troubleshooting questions. Live Chat for interactive support and you can contact us... - Page 7 Troubleshooting Symptom Cause Solution No power between red and white leads in Check fuse. Reset circuit breaker. junction box. Correct improper wiring. Check LVC. See above. Screen will not move “up.” Motor does not hum. Thermal overload tripped (acts as a breaker). Let motor cool for 15 minutes.
- Page 8 Troubleshooting Symptom Cause Solution After securing fabric to roller, loosen set screws on Screen jammed. Will not operate, Closing mechanism detached from door, motor gear and manually rotate solenoid assembly back motor hums, door open, closing allowing it to jam into box. over top of roller into position, then reattach door.
- Page 12 OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE. In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137, Warsaw, IN 46581-0137, (574) 267-8101, (800) 622-3737.