Related Manuals for Da-Lite ELECTROL
Summary of Contents for Da-Lite ELECTROL
- Page 1 ELECTROL INSTRUCTION BOOK FOR COMPACT ELECTROL DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 219/267-8101 800-622-3737 Fax: 219/267-7804 http:// www.da-lite.com e-mail: info@da-lite.com...
- Page 2 Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use an Allen wrench to make adjustments.
- Page 3 SLAT TAPE STRIPS FIGURE 1 MACHINE SCREW ADJUSTMENT KNOB NO. 2 DRYWALL SCREW ADJUSTMENT KNOB NO. 1 DOWN NOTE: MACHINE AND DRYWALL SCREWS ALONG BOTTOM BOARD MUST BE REMOVED IN ORDER FOR THE PAPER AROUND THE FABRIC TO BE REMOVED. FIGURE 2...
- Page 4 INSTALLATION METHOD A METHOD B 4-7/16" 4-7/16" 1-1/2" MOUNTING 1-1/2" MOUNTING BRACKET BRACKET 4-1/4" 4-1/4" 1-1/2" 1-1/2" / 0 1.59 / 0 1.59 FURRING FURRING STRIP STRIP MOUNTING JOIST 2-1/2" 2-1/2" PANEL PANEL MOUNTING JOIST 5" 5-1/4" 1/4" LAG PICTURE SURFACE PICTURE SURFACE SCREWS 3/4"...
- Page 5 COMPACT ELECTROL INSTALLATION 120V WIRING DIAGRAM BLACK TO JUNCTION BOX MOUNTED IN WHITE SCREEN CASE, IN WHICH INTERNAL WIRING TERMINATES IN WHITE, BLACK, AND RED LEADS. MOTOR BLACK (DOWN) OPERATING SWITCH, AC COMMON SWITCH BOX, AND PLATE FURNISHED IN MULTIPLE CONTROL INSTALLATIONS WITH SCREEN.
- Page 6 COMPACT ELECTROL INSTALLATION " " 5" CASE LENGTH=FABRIC WIDTH + 13- ", ALL SIZES " " MOUNTING BRACKET ELECTRICAL OUTLET MOTOR " "...
- Page 7 TROUBLESHOOTING SYMPTOM CAUSE SOLUTION 1. Screen will not operate or will not (a) Blown facility fuse. (a) Replace facility fuse. go “down”. Motor does not hum. (b) Tripped facility circuit breaker. (b) Reset facility circuit breaker. (c) No power to operating switch or (c) Check above.
- Page 8 Da-Lite personnel. Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise. Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
Need help?
Do you have a question about the ELECTROL and is the answer not in the manual?
Questions and answers