Flywheel - Husqvarna K770 Workshop Manual

6.2.10 To assemble the ignition unit
1. Align the magnet on the flywheel with the ignition
unit.
2. Put the air clearance gauge (.01 in/0.3 mm) against
Servicing tools overview on page
the magnets. See
12 .
3. Put the new unit in position. Push it against the
gauge as you tighten the screws. Tighten them with
a torque of 10–12 Nm.

6.3 Flywheel

6.3.1 To remove the flywheel
Use a Husqvarna flywheel puller. Refer to
tools overview on page 13 .
1. Remove the starter and lower air duct.
2. Loosen the springs and put the start hooks in their
outer positions.
701 - 002 -
3. Put a 13 mm socket on the center screw of the
flywheel.
4. Attach the flywheel puller on the socket with the
screw that is supplied with the flywheel puller.
Servicing
5. Hold the handle of the flywheel puller to lock the
flywheel. Remove the nut and washer.
Repair and servicing - 31