Husqvarna K770 Workshop Manual page 26

6.1.8 To clean the spring assembly
Note: Do not remove the spring from the assembly.
1. If the spring is dirty, blow clean with compressed air.
2. Apply a light oil on the spring.
6.1.9 Starter pawls
When the flywheel does not move, the starter pawls are
pushed in the direction of the center by springs. When
the flywheel rotates, the turning force pushes out the
center pawls.
6.1.10 To examine the starter pawls
Note: Do not lubricate the starter pawls.
1. Make sure the springs work and the starter pawls
move freely. Disassemble and clean, if necessary.
26 - Repair and servicing
6.1.11 To disassemble the starter pawls
Note: The position of the washer is below the starter
pawls against the flywheel. Make a note of the position
of the springs in relation to the flanges on the flywheel.
1. Remove the shoulder screws.
6.1.12 To assemble the starter pawls
Note: The spring must not get caught between the
starter pawl and the flywheel.
1. Press the spring into position in the flywheel.
2. Install the washer, starter pawl and shoulder screw.
3. Bend the end of a thin steel wire. Use it to pull the
spring to the mounting on the opposite side.
701 - 002 -