Flywheel - Husqvarna K 760 Workshop Manual

502 51 49-02

FLYWHEEL

Removal
Unhook the springs and place
the start hooks in their outer
positions.
The arrows mark the place for
the tool below.
Tool 502 51 49-02
The special tool is used to
dismantle and assemble the
flywheel.
Centre with socket
Place a 13 mm socket on the
centre screw. Make sure the
springs do not get caught up.
Centre the tool
Fit the plate.
Remove the nut
Removal
Remove the starter and lower air duct.
The start hooks must be in "running
mode" to be able to mount the screws to
the tool below, marked by arrows.
Unhook the springs and place the start
hooks in their outer positions.
Tool 502 51 49-02
A special tool from Husqvarna is
required to dismantle and assemble the
flywheel. The tool fits virtual all fly -
wheels on Husqvarna power cutters.
Centre with socket
Place a 13 mm socket on the flywheel's
centre screw. Push aside the start hook's
springs so that they are not squeezed
between the socket and flywheel.
Centre the tool
Choose a suitable screw, supplied with
the tool, and mount the plate.
Remove the centre nut
Use the special tool's handle to lock the
flywheel rotation and remove the nut
and washer.
7
16