Husqvarna K770 Workshop Manual page 33

CAUTION: Make sure that the inlet pipes are
not damaged and that they have a tight seal to
the air filter and the carburetor. Dust in the inlet
pipes is a sign of dangerous faults in the filter
system. They must be repaired before operating
this product.
1. To remove the air filter, see
on page 20 .
2. When you replace the air filter, examine and clean
the inlet tube.
3. Remove dust from dry cutting with compressed air.
Remove material from wet cutting mechanically.
4. Make sure that the rubber seal on the air duct cover
is not damaged and that it is correctly attached in
the cylinder cover.
701 - 002 -
To remove the air filter
5. Replace the service filter if it is damaged.
6. Do not clean the paper filter. Replace it when the
power of the product starts to decrease.
Repair and servicing - 33