Flywheel - Husqvarna K970 III Workshop Manual

6.2.9 To install the stop switch
1. Push the switch into position (A).
A
B
2. Push the side until it locks (B).
3. Push the side until it locks (C).
4. Tighten the screw. Connect the cable to the stop
switch.
30 - Repair and servicing
6.2.10 To assemble the ignition unit
1. Align the magnet on the flywheel with the ignition
unit.
C
2. Put the air clearance gauge (0.01 in./0.3 mm)
against the magnets. Refer to
overview on page 12 .
3. Put the new ignition unit in position. Push it against
the air clearance gauge while you tighten the
screws. Tighten the screws with a torque of 10–12
Nm.

6.3 Flywheel

6.3.1 To remove the flywheel
Use a Husqvarna flywheel puller. Refer to
tools overview on page 12 .
1. Remove the starter, refer to
on page 14 .
2. Remove the lower air duct, refer to
air duct on page 18 .
3. Loosen the springs and put the starter pawls in their
outer positions.
Servicing tools
Servicing
To remove the starter
To remove the
1444 - 001 - 02.04.2020