Husqvarna K770 Workshop Manual page 30

6.2.8 To remove the stop switch
1. Remove the screw and the cable.
2. Pull the right side of the switch halfway out.
3. Push in the notch on the left side with a screwdriver
and pull the right side half way out.
30 - Repair and servicing
4. Remove the switch.
6.2.9 To assemble the stop switch
1. Push the switch halfway into position.
2. Push in the left side until it locks.
3. Push in the right side.
2
4. Put the cables back on the stop switch..
5. Tighten the screw.
5
4
3
1
4
701 - 002 -