Flywheel - Husqvarna K 750 Workshop Manual

502 51 49-02

FLYWHEEL

Dismantling
Dismantle the starter.
Dismantle the starter pawls.
Tool 502 51 49-02
The special tool is used to
dismantle and assemble the
flywheel.
Centre the tool.
Centre the tool with a 13 mm
socket.
Fit the plate in the holes for
starter pawls.
Dismantle the nut
Press off the flywheel
Fit the screw puller in the centre.
Screw in the centre bolt until
the flywheel releases.
Tip: Knocking the bolt lightly
with a hammer can help to
release a tight fitting fly wheel.
At the same time lift the machine
slightly from the tool handle.
Dismantling
Dismantle the starter. Dismantle the
starter pawls as set out in the chapter
"Starter".
Tool 502 51 49-02
A special tool from Husqvarna is
required to dismantle and assemble the
flywheel. The tool fits virtual all fly -
wheels on Husqvarna power cutters.
Centre the tool.
Put the 13 mm socket on the centre bolt
to help centre the tool.
Select a suitable screw, which is sup plied
with the tool, and fit the plate in the
holes for starter pawls.
Dismantle the centre nut
Use the handle on the special tool to
lock the rotation of the flywheel and
dismantle centre bolt.
Press off the flywheel
Fit the screw puller in the centre and
screw it down as far as necessary to get a
secure fitting in the plate.
Hold the large nut and screw in the
centre bolt until the flywheel releases.
Tip: If the flywheel is very tight,
knocking the bolt lightly with a hammer
to help the flywheel to release. At the
same time lift the machine slightly from
the bench using the tool handle.
7
15