ActronAir LC7-2W Operation Manual page 4

Return to Home Page
Operation Manual
with current electrical authority regulations and all
wiring connections to be as per electrical diagram
provided. Always use appropriate PPE for your safety
and protection. Make sure that any safety guards and
covers are always firmly secured and not damaged.
WH&S rules and regulations must be observed at all
times and will take precedence during installation
process and operation of the unit.
In addition, the following instructions must be
observed:
• Prevent the electrical components and electronic
circuits from getting wet.
• Do not install the controlling devices in a particularly
hot environment as extreme temperatures may
damage the electronic equipment.
• Do not attempt to open the control and other
electronic devices in any way other than described in
this manual.
• Do not drop, shake or hit the devices, which can
cause irreparable damage to its internal circuits and
mechanisms.
• Do not use corrosive chemicals, solvents or other
aggressive detergents to clean the unit and the
control interface.
• Do not use the unit for applications other than those
specified in the technical manual.
• Do not install the unit in environment with highly
flammable, combustible and/or explosive articles
and materials.
• This control interface must be installed in a location
that complies with the temperature and humidity
limits specified in this manual.
ActronAir is constantly seeking ways to improve the
design of its products, therefore specifications are
subject to change without prior notice. Please check
with ActronAir Service Department on toll free number:
1800 119 229.
SPECIFICATIONS:
• Voltage: 12VDC +10% (LC7-2 control connects
directly to the Indoor board)
• Data: RS485/Cat5e Twisted Pair 7/0/20 (AWG24)
Shielded Data Cable, Maximum Cable Length up to
200 m
• Storage conditions: -20 to 70
condensing
• Operating conditions: -10 to 60
condensing
LC7-2 Wall Control
o
C, < 90% RH non-
o
C, < 90% RH non-
Page 4