Table of Contents
Advertisement
#$ Other Connectors
#$
#$
#$
#$
ATX Power Supply Connector (CN10)
E1
Locate the 20-pin male header ATX power connector (CN10) on your
mainboard. Plug the power cable from the ATX power supply unit directly
into CN10 ATX power supply connector.
Note 1: The ATX power connector is directional and will not go in unless the
Note 2: Make sure the latch of the ATX power connector clicks into place to
Note 3: Your ATX power supply must be supplied to ACPI +5V standby power
Note 4: Make sure your power supply have enough power for higher speed
Cooling Fan Connectors for CPU FAN (FAN1), SYSTEM FAN
E2
(FAN2), and AGP FAN (FAN3)
The mainboard provides three onboard 12V cooling fan power connectors
to support CPU FAN (FAN1), SYSTEM FAN (FAN2), and AGP(FAN3) cooling
fans.
FAN1, FAN2 with rotate sense.
FAN3 without rotate sense.
Note:
Both cable wiring and type of
plug may vary depending on
the fan maker. Keep in mind
that the red wire should always
be connected to the +12V
header, and the black wire, to
the ground (GND) header.
guides match perfectly making sure that pin#1 is properly positioned.
ensure a solid attachment.
and at least 720mA compatible.
processor installed.
1
GND
+12V
FAN1
1
SENSE
- 37 -
FOR CPU
1
FAN3
FOR AGP
1
FOR SYSTEM
FAN2
ATX PWR CON
CN10
Advertisement
Table of Contents
